So-PowerPoint PP-VIP10-3,5t-M27 with max-length F=92

Description

Thread reach from F = 92 mm is available.

When ordering implicitly indicate the required length. WLL is equivalent to that of WBG-V, since a corresponding lower part is used.

Connection only with RUD approved components e.g; VCÖH-10 , oval link, PP 3500 kg or the 10 mm VIP chain. Hint : The VIP chain connection is fool proof. When assembling the components, pay attention to the correct WLL allocation. Choose the attachment points in such a way that the introduced forces are accomodated by the work piece without being deformed. Work piece material, at least 1.0037 (St 37).

The BG recommends the following min. thread lengths:
1 x M for Steel
1.25 x M for Cast
2 x M for Aluminium

For light metals, nonferrous heavy metals and grey cast iron, the thread type allocation must be done in such a way that, the WLL of the thread type fulfils the requirements of the respective work piece.

Even under full load, can be turned in a 90° position from the bolt centre line. Not suitable for permanent swiveling under full load. Make sure the bolting surface is plain. Ensure an appropriate bore depth to facilitate an optimal sitting of the engaging surface. For a single transportation procedure, bolting in and fastening tightly with a flat wrench is enough.

Without a washer, the seat - engaging surface of the Power point (D) must completely lie onto the surface of the work piece. Is the Power point to be permanently loaded, it must be tightened with a torque of 200 nm. When impact loaded or operated in environments with skewing and vibrations, unintentional loosening can happen, especially if through bolts with nuts are used.