|
 |
| |
| |
|
|
 |
 |
|
| |
to Wire
Rope End Attachments Main Page |
|
| |
|
|
 |
| |
|
|
|
|
|
Cable Grips for Wire
Rope Installation
are made from a wire hollow braid. They are being pushed over the rope end
and tighten as soon as tension is applied. Our cable grips are made from
a heavy duty strand which is much stiffer and much stronger than the one
commonly used for electrical cable installations. Also, our grips are much
longer in length to provide increased holding and gripping force.
Most common type for smaller diameter ropes is 'Open Ended'
to pull same sized wire ropes.
'Loop Ended' are preferred for larger diameter ropes. They
allow to install a swivel between the grips to compensate for rope rotation. |
| |
| |
| Open Ended Cable Grip |
| |
|
|
 |
| |
|
|
|
|
|
|
|
|
For Nominal
wire rope
diameter
inch |
Part # |
Made from
no. of plys |
Open Ended
pulling capacity
lbs |
Grip Length
inch |
|
| 1/4 to 9/16 |
CG-OEG-025 |
2 |
1,150 |
59" |
| 9/16 to 1 |
CG-OEG-062 |
2 |
1,550 |
78" |
| 7/8 to 1-1/4 |
CG-OEG-088 |
3 |
2,920 |
78" |
|
| 1 to 1-1/2 |
CG-OEG-125 |
3 |
3,500 |
78" |
| 1-1/4 to 2 |
CG-OEG-162 |
3 |
7,200 |
78" |
|
| |
|
|
| |
|
|
| Loop Ended Cable Grip |
| |
|
 |
| |
|
|
|
|
|
|
|
|
For Nominal
wire rope
diameter
inch |
Part # |
Made from
no. of plys |
Loop Ended
pulling capacity
lbs |
Grip Length
inch |
|
| 5/16 to 9/16 |
CG-LEG-031 |
2 |
1,150 |
49" |
| 9/16 to 1 |
CG-LEG-062 |
2 |
1,550 |
49" |
| 7/8 to 1-1/4 |
CG-LEG-088 |
3 |
2,640 |
49" |
|
| 1 to 1-1/2 |
CG-LEG-100 |
3 |
3,170 |
49" |
| 1-1/4 to 2 |
CG-LEG-200 |
3 |
6,450 |
59" |
|
| |
| |
| |
|
|
 |
|
|
|
|
|
| Part.
No.: CG-SW |
|
| Diameter |
7/8" |
| Total
Length |
3-3/16" |
| Pin Diameter |
5/16" |
| Jaw Opening |
5/16" |
|
Installation Swivel
To connect 2 Loop ended Cable Grips together. This allows the installer
to have the old- and new rope separated with a swivel to prevent torque
and rotation transfer. |
|
|
|
|
|
| |
|
Back to Top |
| |
|
|
|
